*Based on 710 Hour Salt Spray Test Results
Fire requires three elements to ignite: the same is true to ignite the corrosion process.
Valspar Aquaguard dramatically outperformed standard solvent-based coatings with zinc in this 710 Hour Spray Test
On average the corrosion is reduced by at least 60% on tested areas
Corrosion resistance of this zinc rich primer, epoxy mid coat and acrylic topcoat industry control. The corrosion cell, (Defined as the area below the coating substrate interface) was measured at 310 micron wide and a pit depth of 95 micron.
The depth of pit shows just how far into the container the corrosion was able to reach.
The corrosion cell was reduced by approximately 60% compared to the Panel 1 control.
There is noticeably less red rust inside the scribe.
Reducing Solvents and Zinc
Reduced solvents and zinc lessen the weight of a container AND reduce odor.
DOING ANY OF THE FOLLOWING STOPS A FIRE:
DOING ANY OF THE FOLLOWING STOPS CORROSION:
SOLVENT-BORNE / ZINC BASED COATINGS:
VALSPAR AQUAGUARD WATERBORNE COATINGS: